Commander Pulse Bedienungsanleitung PDF herunterladen (Seite 10)

Assembling your DECT phone(s)

Insert the two rechargeable NiMH batteries size AAA

1.2V 750mAh, ensuring their polarities are correct, into

the battery compartment of the handset.

Slide the battery door firmly into place.

Step 5:

Connecting your

DECT phone(s)

Registering your DECT phone(s)

On the Commander Pulse unit, hold down the ‘Page’

button for 4 seconds.

This places the Commander Pulse in registration mode for

30 seconds.

Place the handset on the charger unit and plug the unit into

the mains power. Allow the batteries to charge for a full 14

hours before using the handset for the first time.

The handset may get warm

during initial charge.

You will know that the Commander

Pulse is in registration mode when

the power led flashes red and green.

Page button

> Press ‘REG’ on the DECT handset

> Press ‘OK’ for ’REGISTER’

> Enter the PIN number of 1234

> Press ‘OK’

> The DECT handset is now registered to the

Commander Pulse

Pressing the ‘PAGE’ button normally

rings all DECT phones registered to the

Commander Pulse. This can be used

to locate misplaced DECT phones.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Keine Kommentare

Commander Pulse Bedienungsanleitung Seite 10